Which is the best one for Jiangxi spiral chutes? Overview: Gravity separation is widely used in the beneficiation of metal and non-ferrous metals due to its low pollution and low cost. Spiral chute is one of the gravity beneficiation machines, characterized by a cubic parabolic cross-section, suitable for processing finer particle sizes of -0.2 millimeters. During the sorting process, there is no need to add water for flushing, and the end of the chute is divided into sections to select fine, medium, and tailings. 2、 Operating principle: The spiral chute concentrator does not need to be restricted from being placed on the cross (or tripod) on the support table. The same mineral mortar is slowly fed onto the surface of the rotating groove through the feeding chute at the end of the installation spiral groove head, and selected for operation. The bottom is equipped with a valve block type equipment to obtain slots, allowing the sorted products to be divided into three (or four) types according to grade along the radial direction. Change the selection width of each device by adjusting the position of the valve block. The product gathering bucket is a concentric circular tube that collects and leads the intercepted multi head ore flow separately. The cross-section of the fiberglass chute and the change in slope of the curve are very suitable for the sorting of fine-grained materials. Which company is good for Jiangxi spiral chutes The structural composition of the spiral chute is composed of six parts: a feeding homogenizer, a feeding chute, a rotating chute, a product intercepting chute, an equipment gathering hopper, and a groove bracket (including a cross or triangular frame). The spiral groove connected by the rotating plate is a key accessory. The spiral plate is made of fiberglass (fiberglass reinforced coal gangue) and connected together through screws. The sorting surface of the rotating groove has one layer of pre designed durable wear-resistant layer. It has the advantages of lightweight, sturdy, and durable consumer goods. The spiral groove is equipped with a multi tube feeding homogenizer to screen minerals evenly, which is not cumbersome to operate. The mineral sorting equipment is freely stacked on the cross (or tripod) of the support table. The evenly distributed mortar is slowly fed to the spiral groove surface through the feeding groove installed at the head of the rotating groove, and the selection is carried out. The bottom of the rotating groove is installed in a valve block type new equipment to obtain the groove, allowing the sorted new products to be divided into three (or four) new products according to grade along the radial direction. Change the selection width of each new device by adjusting the position of the valve block. The new product gathering bucket is a concentric circular tube that distinguishes and converges the intercepted multi head ore flow. The cross-section of the fiberglass chute and the change in slope of the curve are particularly applicable for the selection of fine-grained materials. Which company is good for Jiangxi spiral chutes? 5. The utilization field of fiberglass chutes is suitable for processing 0.6-0.03MM and vein minerals, but high mud content is unfavorable for sorting. It is now widely used for processing iron ore, tungsten, sand tin, tantalum niobium ore, bay and riverbed ore sand or placer gold, and so on. Which is the best place for Jiangxi spiral chutes at 
